KUTAI MANUAL KEY START GENSET CONTROL UNIT # GCU-30

Manual Key Start Genset Control Unit
GCU-30 Manual Key Start Genset Control Unit has many useful functions and engine protections like the charge alternator failure protection. It's suitable for most available Rental market generators.

Features

• Microprocessor based design
• LED status indicator with graphic interface
• Modular design with easy installation
• UV protection with minimum waterproofing (IP51)
• Charge alternator failure protection
• Start and Pre-Heat function push button
• Three DIP switches for configuration
• Suitable for most available genset on the rental market

Specifications

• DC Supply: 9 to 36 Vdc
• Rated AC Input Voltage:5 to 300 Vac
• AC Frequency:50/60 Hz
• Fuel Solenoid Signal Output: 1.2 Amp @ 12/24 Vdc
• Start Signal Output: 1.2 Amp @ 12/24 Vdc
• Preheat Signal Output: 1.2 Amp @ 12/24 Vdc
• Charge Motor Excitation Signal Output: 12/24 Vdc
• Power Consumption: Under 3 watts

System Setting
                                                    ON                          OFF
SW1 AC Frequency Setting        50 Hz                       60 Hz
SW2 Stop Mode                          Energized to Start    Energized to Stop
SW3 Engine Stop Timer Delay    20 seconds              10 seconds

Protection and Alarm Status Indicators

• High Coolant Temperature Protection
• Low Oil Pressure Protection
• Engine Over speed Protection
• Charge Alternator Failure Protection
• User Define Protection

Environment

• Operating Temperature: -20 to +60 °C
• Storage Temperature: -40 to +85 °C
• Relative Humidity: Less than 90%

Physical Specifications

• Panel Cut-Out: 66.0 x 66.0 +/-0.5 mm
• Dimensions: 72.0 (L) x 72.0 (W) x 37.0 (H) mm
• Weight: 101 g +/-2%