KUTAI AUTOMATIC GENERATOR ENGINE CONTROLLER / CONTROL UNIT # GCU-10

The GCU-10 is an economical genset controller, giving high reliability for much less than similar controllers. It has adjustable settings to enable it to work with any type of generating set and comply with different engine conditions and protections. Optional 12V/24V relay boards (GCU-11R) are available for simplifying wiring and connections.

Features
• Microprocessor based design
• LED status indicator with graphic interface
• Modular design with easy installation
• Adjustable settings to suit wide array of generator set application
• UV protection with minimum waterproofing (IP51)
• Provide IDLE control for Elec. Governors
• Five adjustable time delay potentiometers
• Five DIP switches for configuration
• Optional GCU-11R (12/24Vdc) relay module to simplify connection and provide additional protection to controller

Specifications
• DC Supply: DC Voltage 9 to 36 Vdc
• Alternator Input Range: AC Voltage 5 to 300 Vac - Frequency 50/60 Hz
• Fuel Solenoid Signal Output: 5 Amp @ 12/24 Vdc
• Start Signal Output: 5 Amp @ 12/24 Vdc
• Warm up Signal Output: 5 Amp @ 12/24 Vdc
• Accessory "ON" Output: 5 Amp @ 12/24 Vdc
• Idle Control Conductor Capacity: 5 Amp @ 12/24 Vdc
• Power Consumption: Under 3 VA on Auto

Protection & Alarm Status Indicators
• Start Failure
• High Coolant Temperature
• Low Oil Pressure
• Overspeed
• Underspeed
• Emergency Stop
• Extra Prog. Input
• Low Battery Voltage

Adjustable Timers
• Engine Pre-Heat: 2 to 30 seconds
• Starter Cranking Time: 1 to 15 seconds
• Energize to STOP: 1 to 30 seconds
• Engine Idle (Governor): 0 to 300 seconds
• Engine Cool-down: 0 to 300 seconds

Environment
• Operating Temperature: -20 to +60 °C
• Relative Humidity: Max. 90%

Physical Specifications
• Panel Cut-Out: 66.0 x 66.0 +/-0.5 mm
• Dimensions: 72.0 (H) x 72.0 (W) x 50.0 (D) mm
• Weight: 166 g +/-2%